Bridge calibration unit

BN100A - Bridge calibration unit

The BN100A bridge calibration unit is a highly precise calibrator to calibrate measuring equipment and measurement chains which function with a carrier
frequency of 225Hz. In the first instance the BN100A is intended for the calibration of the DMP40 and DMP40S2 digital precision instruments.

Product Description

The BN100A bridge calibration unit is inserted in the measuring system to be calibrated in place of the transducer (full bridge), or is connected directly with the measuring instrument, and simulates with the aid of switchable inductive dividers the output signals of the transducer in a range of ±100mV/V.

The unique precision of the simulation of the transducer signals is effected by a control circuit which additionally reduces the low error of the inductive divider stages of a large degree. The full accuracy of the BN100A only comes into effect when it is connected in the six-wire-circuit. The calibration error will then be max. 5ppm with a signal of 2mV/V.

Product Literature

Please enter your email address.

If you already have an account with HBM.com, log in here using your email address to get unlimited access to HBM's complete technical documentation.

Product Literature

BN100A
BN100A ENDEESFRITPTCNJPKRRU
Data Sheet Please Log InPlease Log InPlease Log InPlease Log In
Operating Manual Please Log InPlease Log In
CE-Declaration of Conformity Please Log InPlease Log InPlease Log In

Candid data sheets: We keep our promises.

Precision in series: This also applies to the accuracy of the values specified in our data sheets. Ideal conditions can often be theoretically attained based on the values given, but our data sheets focus on realistic standard assumptions - such as those likely to be encountered in your application. Therefore, please consider this when comparing our data sheets with those of other manufacturers.

Get a Quote for BN100A

Request a Quote for BN100A

Thank you for your interest in HBM. Please complete the form below and an HBM representative will respond shortly.


Key Features

  • High-precision simulation of defined output signals of 350ohm strain-gage full-bridge transducers
  • Calibration signal adjustable in 0.1mV/V steps in the range from -100mV/V to +100mV/V
  • 0.0005 accuracy
  • For transducer excitation with 225Hz carrier frequency

Order Number

1-BN100A