Z70 Adhesive

Z70 - Single component adhesive

Z70 is a single component, cold curing adhesive made of cyanacrylate. Curing is only possible on very slight adhesive films and at room temperature under thumb pressure. The air humidity needs to be between 40% and 70% as a catalyst for the curing process.

A curing of Z70 is not possible under certain unfavorable conditions (as very low air humidity (< 40 %), surfaces with acid reaction or low temperatures). In this case, the accelerator BCY01 can be used.

Delivery: Reclosable plastic bottles (10 cm³).

The following accessories are included in delivery:

  • Fluoropolymer release film
  • Fluoropolymer strip
  • Drop dosing device
  • Manual and Security Data Sheet

Please enter your email address.

If you already have an account with HBM.com, log in here using your email address to get unlimited access to HBM's complete technical documentation.

Product Literature

Instructions for use Please Log InPlease Log InPlease Log InPlease Log In

Candid data sheets: We keep our promises.

Precision in series: This also applies to the accuracy of the values specified in our data sheets. Ideal conditions can often be theoretically attained based on the values given, but our data sheets focus on realistic standard assumptions - such as those likely to be encountered in your application. Therefore, please consider this when comparing our data sheets with those of other manufacturers.

Get a Quote for Z70

Request a Quote for Z70

Thank you for your interest in HBM. Please complete the form below and an HBM representative will respond shortly.