Exemples de mesures appliquées
Les Reports in Applied Measurement (exemples de mesures appliquées) est un journal détaillée sur les techniques de mesure constitué d'articles soumis par des auteurs indépendants.
RAM est une longue tradition sur les expériences réalisées depuis le milieu des années 60.
Il est édité par Dr. Martin Stockmann de l'Institut de Mécanique à l'université de Chemnitz en Allemagne. Cet édito est semestriel, il est publié en anglais et Allemand exclusivement sur notre site Internet.
The thermal output of a strain gage
The purpose of this article is to explain the causes of thermal output in strain gages and to show methods by which the effects can be minimized.
Measuring acceleration in a 360° looping orbit
A Bavarian manufacturer has built a looping track with a 360° loop for an amusement park in California.
Experimental verification of the load-bearing capacity of a multilevel car park in Bremerhaven
An increasing proportion of construction work involves the maintenance and refurbishment of existing buildings whose load-bearing capacity cannot be established by analytical methods
Stress calculation from measured strains in the elastic deformation range
Experimental stress analysis using strain gages is carried out in two sequential steps.
Performance of the inductive force transducer Q11 under high-energy spallation neutron irradiation
Components used in nuclear engineering are subject to irradiation-induced structural changes as well as mechanical and thermal load.
Loading behavior of pile groups studied with the aid of inductive displacement transducers and strain gages
In order to study the vertical loading behavior of piles, large-scale model experiments have been performed using single piles and pile groups of different sizes and lengths, with loading continued until failure of the total...
Applying force transducers and strain gages for rollbearing force measurements on continuous dewatering pressure filters
In order to optimize the design of the frame of a 22 metric ton (24.2 English tons) band filter press for iron ore slurry, it was found necessary to measure the bearing forces at the high-pressure rolls and pressure rolls while...
Stress tests with strain gages on the "UBS-Switzerland" before her participation in the Round The World Race
Before her participation in the Whitbread Round The World Race, the Swiss racing yacht "UBS Switzerland" underwent an extensive series of stress tests during a North-Atlantic crossing.
The measurement instrumentation of MV "Polarstern" for an icebreaking expedition
The design of the vessel, as well as the local hull construction of an icebreaking ship is largely based on empirical data obtained from vessels operating in the Baltic Sea.
Precision force transducer for international comparison measurements on force standard machines
International comparison measurements performed on the force standard machines of national metrological institutes require standards in the form of force transducers which must possess qualities that can satisfy the very highest...
