Setup a Calculated Channel „Trigger Pulse“.
- The measured force value is the input signal
- A predefined value can be set as limit
- A condition is selected „Trigger on going above“
- The output is given to „Flag01“
Event counter
In this example, the overpassing of a force value should be counted and displayed. Once the count 5 is reached, this should be signaled on a digital output. Then the operator can set the count back to 0 again.
The following example shows how to setup an event counter in PMX. Two Calculated Channels are required therefore.
Setup a Calculated Channel „Counter“.
These examples are simply for the purpose of illustration. They cannot be used as the basis for any warranty or liability claims.