Calculating the force introduction point with PMX

Determining the force introduction point on a plate with three force transducers.


The coordinates of a force F to be measured can easily be determined with three force transducers F1, F2 and F3.




Force F is the sum of the three individual forces:

The counters for the x and y calculation are determined in an interim step. Coordinates x1, y1, x2,....are in the factors of the summands.

For x:

For y:

Finally x and y are calculated with two divisions. The calculation for x is shown here (y is similar):

Implausible values in unloaded state

Noise predominates when F is close to zero. Implausible values are returned for x and y:

Remedy: Output for x and y is not regular until F is greater than 1 N, for example. Otherwise zero will be returned each time.

A trigger block sets Flag_01 if F is greater than the minimum value:

The two limit values for the trigger. Only the lower switching threshold is required for 1 N. A value is selected for the upper threshold that is far above the measuring range:

Two multiplexer blocks switch between zero and the calculated values. Shown here for x:


  1. In case of division by zero, a divisor block returns Not-a-Number (NaN).
  2. Polar coordinates can also be returned if necessary:

The settings for radius....:

Representation of a moving force with catman in polar and Cartesian coordinates:


These examples are simply for the purpose of illustration. They cannot be used as the basis for any warranty or liability claims.

Kontakta Här kan du kontakta oss för att få veta mer om vad HBM kan erbjuda dig.