High Voltage ISO 2 MS/s Input Card with enhanced math (GN610B)

The isolated balanced differential input offers voltage ranges from ± 10 mV to ± 1000 V, a 7-pole Bessel and Butterworth analog antialiasing filter, user-selectable digital Bessel, Butterworth and Elliptic IIR filters and an 18 bit Analog-to-Digital converter operating at up to 2 MS/s. 
Tested up to 6.4 kV, the reinforced isolation allows for safe measurements up to 600 V RMS CAT II (IEC61010-1:2010 safety standard). The two timer counters together with the GEN series mainframe Digital Event/Timer Counter connector and the G070A torque/RPM adapter allow for direct interfacing to HBM torque transducers or other torque and speed sensors.

Besides the instantaneous values, the realtime cycle detection allows for cycle based real-time calculations like TrueRMS on all analog channels as well as torque, angle and speed on all timer counter channels simultaneously.
The real-time formula database calculators option offers an extensive set of math routines to solve almost any real-time mathematical challenge like obtaining mechanical power and/or multi-phase (not limited to three) electric power (P, Q, S) or even efficiency calculations. Every calculated result either from the real-time cycle based calculators or the real-time formula database calculators can be used to trigger the recording.

Special Features

  • 6 analog channels
  • Isolated, balanced differential inputs
  • ± 10 mV to ± 1000 V input range
  • 600 V RMS CAT II reinforced isolation, tested up to 6.4 kV
  • User-selectable digital Bessel, Butterworth and Elliptic filters
  • 2 MS/s sample rate
  • 18 bit resolution
  • 2 GB memory
  • 4 mm banana connectors
  • Real-time cycle based calculators
  • Real-time formula database calculators (option)
  • Triggering on real-time result
  • Digital Event/Timer/Counter support
GEN3i
GEN3i is a powerful and fast data recorder. It offers both continuous direct-to-disk with up to 200 MB/s as well as fast transient recording.
GEN7i
GEN7i is a powerful and fast data recorder.It offers both continuous direct-to-disk with up to 350 MB/s as well as fast transient recording.
GEN3t
The powerful GEN3t high-speed data acquisition system from HBM is designed for installation in control cabinets (19 ''), therefore very compact.
GEN7tA
Offers high speed and high channel count data aquisition and transient recording for high end requirements. Rapid, reliable, flexible and precise.
GEN17tA
The GEN17tA offers high speed and high channel count data acquisition and transient recording for high end requirements.
HBMshop Se priser, tillgänglighet och skriv ut prisinformation.
Begär en offert!

Fråga din försäljningsingenjör

Skicka mig:


Starta din förfrågan

Fråga din försäljningsingenjör

Skicka mig:


Starta din förfrågan

Individuellt erbjudande

Teknisk rådgivning

Snabb återkoppling